![]() |
|
#6
|
||||
|
||||
|
Yesterday was a busy day for the old Zenith. I disassembled, cleaned and reassembled both the VHF and UHF tuners. One really has to admire the way these tuners were built. I cleaned all the contacts, removed the turret and lubricated the moving parts. Everything went together well with no pieces left over
I had to reglue the convergence magnet assemblies as they were starting to come apart. The chassis is cleaned up, all controls sprayed with Deoxit and the tubes polished with Windex. This set must have been in a smoker's home because there was brown crud on practically everything. Although I can't hook up the CRT and test it thoroughly because the cabinet is still not ready, I was able to hook up the tuners and speaker. The signal path seems to work (at least the audio portion) as I have sound reception on all channels. The vertical oscillator is running and its pitch varies with the vertical hold control. The high voltage section is operating and I was able to get almost 30 KV out of it. I did not run the HV for too long as I just had the probe hooked up. I know I need to adjust the efficiency coil. When the set is back together I will go through all the setup procedures in the Sams. When I first powered it up I saw a little smoke rising from an opening in the chassis. There was no component burning smell, however, just the smell of tubes and burning dust. I think that is all it was since it has stopped and careful observation reveals nothing out of order. I can't check the video and color circuits as I don't have a scope. I'll just have to wait for the cabinet and really test it when I can install the tube. The sound on this set is amazing. Even with just the small oval speaker, the set has more volume and richer tone than our 27" HDTV with stereo and BBE, etc. I will post another update when I get the cabinet back.
__________________
Just look at those channels whiz on by. - Fred Sanford |
| Thread Tools | |
| Display Modes | |
|
|