Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 05-02-2007, 09:06 PM
Adam's Avatar
Adam Adam is offline
VideoKarma Member
 
Join Date: Oct 2005
Location: Phoenix, AZ
Posts: 2,383
Working again.

The plate voltage at the 6EW6 is supposed to be 400v, and not 50, I checked it against another schematic and then I checked it again after the set was working (the 50v must be a misprint). The screen voltages and grid voltages were a bit low, but not by much.

The color intensity control would cause it to go from a b/w picture to a b/w and green picture.

The voltages at the 6JU8 phase detector would vary from 20 to 40. When I checked it the set would loose color sync all together and have the horiz color lines, but when I removed the meter it would go back to white and green.

Anything hooked to the 265v source tested about 30v low.

I replaced several resistors that were 10-20% off, but it made no difference.

Finally, not being able to find the source of my troubles, but pretty sure it did have to do with the color sync circuits, I hauled the scope behind the set and tested the 3.58mhz oscillator. I was getting a signal, I was trying to figure out if the frequency was right or not, then I just decided to try to hook the probe to one of the leads going to the crystal, and see what I got, then when I looked at the picture on the screen (the set not the scope) the color was back. I removed the scope probe, not working again. I tried just clipping a wire where I had the probe, and it still worked. I resoldered the crystal to the board, and that was all it needed.

A different Bewitched Zenith...

Last edited by Adam; 09-13-2009 at 10:37 AM.
Reply With Quote
  #2  
Old 05-06-2007, 09:34 PM
wa2ise's Avatar
wa2ise wa2ise is offline
VideoKarma Member
 
Join Date: Dec 2002
Location: USA
Posts: 3,147
Quote:
Originally Posted by Adam
Finally, not being able to find the source of my troubles, but pretty sure it did have to do with the color sync circuits, I hauled the scope behind the set and tested the 3.58mhz oscillator. I was getting a signal, I was trying to figure out if the frequency was right or not, then I just decided to try to hook the probe to one of the leads going to the crystal, and see what I got, then when I looked at the picture on the screen (the set not the scope) the color was back. I removed the scope probe, not working again. I tried just clipping a wire where I had the probe, and it still worked. I resoldered the crystal to the board, and that was all it needed.
Modern scope probes have about 10pF of capacitence, so a 10pF cap to ground might be what you needed.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:09 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.