![]() |
|
|
|
#1
|
||||
|
||||
|
They may as well take their money, toss it in the air & go "Whee !" for all the good those old junky caps are..
__________________
Benevolent Despot |
|
#2
|
||||
|
||||
|
People who restore vintage electric guitars want authenticity and say that they prefer the sound that results. Similar to the audiophools who rave about that "warm tube sound" from old gear. I suspect some of these are going into guitar amps, as well.
Maybe it's not that crazy. Half of the controls on my s-s guitar amp are there to create distortion of one sort or another. Think of fuzz boxes, etc. I doubt there's much risk in an electric guitar, where there can't be much voltage involved. I would be more concerned about putting these in an amp, however. Look at this way -- another source of income for us radio/TV types who automatically replace all caps of this type. Phil Nelson |
|
#3
|
||||
|
||||
|
Phil Nelson wrote: "People who restore vintage electric guitars want authenticity and say that they prefer the sound that results."
I could never quite figure out what these vintage guitarists want. Do they want the sound produced by leaky caps? If so, then why change out the leaky caps that are already in the amp with other leaky caps? If they want authenticity, like the amp orginally sounded, then they need to install new non-leaky caps. I suppose they think the amps were built with leaky caps. |
|
#4
|
||||
|
||||
|
"... why change out the leaky caps that are already in the amp with other leaky caps?"
Maybe they are removing the perfectly good caps modern caps that a previous owner installed, and adding these old bad caps? And not only is this ridiculous, the whole "relic-ing" guitars now... it disgusts me. At my local music store last week I saw a BRAND NEW Telecaster that had been made to look old. Worn fretboard, varnish missing off the body, belt buckle rash, etc. And it was priced higher than one in unused mint condition. Go figure. I think it came from Fender that way as well. |
|
#5
|
||||
|
||||
|
Quote:
Phil Nelson |
| Audiokarma |
|
#6
|
||||
|
||||
|
The listing has 125 hits, but still no bidders...
Being a big fan of Sprague caps, I wonder if this series had the "Difilm" construction, and whether they still use foil vs. sprayed-on metal as I assume the current 225P series, for example, does. Maybe someone with some catalogs can research this. I also remember Cornell-Dubilier being mentioned as a source of Bumblebees. I actually have some NOS 160P .1 @200's in my stock, they have no date code. My Tel-Ohmike is in storage, so I can't definitely measure them right now. I got them from Radar Electric's "wall of jars" in 1986. Any other AK'ers in the NW remember going there? It was like being a kid in a candy store, but the jars were full of NOS caps, resistors, transistors, etc. that were overflow or de-stocked. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|