Toshiba 65HDX82 - Wavy Lines

[L200B]

So, new development.

Now the red projector has gone out of alignment. Creating a red wave across the screen.

Before I made this post I read some stuff online which lead me to believe the convergence board was going.

My question is, is the red being out of alignment related to the jitter?

I see one cap on one of the main boards that is swollen. At this point I'm not sure which board is which. Just digging in.

I do see caps on the boards connected to the projectors. I don't know anything about the terminology relating to this stuff. but, should I mess with the smaller boards on connected to the red projector or should I just stick to the board where I already see the swollen cap?