![]() |
|
#11
|
||||
|
||||
|
If those resistors are truly as low as you are measuring then they are badly out of tolerance and need to go ASAP....That said it's been a while since I've looked at the schematic and there could be a parallel path creating a false reading. In any event if you don't want to be doing tons of cross referencing for replacement transistors that might get damaged, then your next move should be to unsolder a leg of each of those resistors and double check how they measure and IMMEDIATELY change them if they have drifted low and are out of tolerance.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
|