Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 12-07-2021, 01:33 AM
vortalexfan vortalexfan is offline
VideoKarma Member
 
Join Date: Sep 2018
Location: Northern Indiana
Posts: 1,992
Quote:
Originally Posted by Kevin Kuehn View Post
How does your 245 volt B+ source measure where it feeds the 470(R56) ohm resistor?

If you have not replaced electrolytic caps C3B, C3C and one or both are very leaky it would certainly have that affect of drawing lots of current, pulling down voltages and cooking the 470 ohm resistor feeding that audio circuit. C51 being leaky could cause low audio, however it alone should not pull your voltages on the 5AQ5 down that low. It's highly suspect that one of the above electrolytic caps has either not been replaced or has become shorted(possibly installed reverse polarity). Certainly you've tested the 5AQ5 for shorts.
I have replaced all 3 caps for C3 with brand new caps and I made sure to observe proper polarity, as for the 245V supply to R56 its only measuring about 220V for some reason.

As for the 5AQ5 tube, I've tried subbing in a known good 6AQ5 tube (as I don't have any 5AQ5 tubes, and plus I know on series string sets you can get away with upping the the tube voltage a little bit because of higher line voltages) and I get the same results.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:12 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.