UPS RPT-800A REPOTEC cONNECTING

[svhs]

For dumb UPSes (such as RPT-800A REPOTEC) using voltage signalling, if you are going to build your own cable, we recommend to make the cable designed by the apcupsd team as follows:hi
my ups hawe pinout 5`2`4`6`7 db9 - its slight diferent from above sheme
https://networkupstools.org/cables.html#_tripp_lite
AND soft-app searhcing help me for non tx-rx com port ups soft

5+2 Shutdown load
5+4+8 Cable power (must be present for cable to have valid reading)
5+6 On line (no power failure) (opposite of OB - on battery)
5+7 Low battery
https://www.cyberpowersystems.com/products/software/

Example Application
Supply 12VDC to the COMMON contact and connect LEDs to the DB-9
port pins 1, 2 and 6 to 9. Connect a push button to COMMON (Pin5) and
REMOTE SHUTDOWN (Pin4). Pressing the button for at least 5 seconds
will shutdown the UPS when it is on battery.
Note: When the UPS is on battery, the REMOTE SHUTDOWN input (Pin4
& Pin3) accepts at least 5 seconds of high level signal (+12VDC) to perform
the UPS shutdown. UPS output power will turn off after 120 seconds.

The default communication speed for all UPSs is 1200 baud.
For some optional cards, the communication speed could by 9600 baud.