Predicta Holiday Vertical Hold

[Daniel6co]

I've been in the process of troubleshooting my Holiday set for the past few days and I'm starting to run out of ideas. I have replaced all capacitors on the main board as well as underneath and also replaced many resistors that I found were out of tolerance. I've checked my work several times now hoping to find a mistake, but my replacememts all look good. My issue with the set is that I cannot get good vertical lock. I've replaced the K4 network and the others with those made by Crist. And the .0015 1000v cap in that area of the board. The set will lock for 10 to 20 seconds then roll for a bit then re lock. I suspected it might have been a weak signal from my blonder tongue, but with a direct hook up it was no better. When I turn the height and vertical lin controls to their minimums I can get hold for about a minute at a time, but it still drifts. I've subbed the 10DE7 and others but no improvements. I haven't touched the 390pf mica cap on the board, and remember bandersontv said that those were sometimes flakey in one of his vids. Shango66 also had poor vertical lock on that barber pole he resurrected, but his fix for it didn't work for mine. This is my first Predicta restore, im stumped, anyone have any ideas?

Sent from my SM-G988U using Tapatalk