|
|
|
#12
12-23-2015, 01:13 PM
|
||||
|
||||
|
Try (with the unit unplugged) turning the motor shaft/worm gear by hand (try to manually move the tray through it's full load/unload cycle) and see how much resistance there is....It is possible the grease on the load gears is starting to act more like glue....It's been about 5 years since I worked on mine, but IIRC the cassette load mech needed needed some fresh grease.
Load motors usually are not a high failure item in Sonys (you could try removing it letting it free run, and maybe applying mech resistance with your fingers to check it). Only load motor I've ever had to change was in a NEC S-VHS deck.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode