|
Okay, looking at various tube diagrams, it seems that holding the tube so the gap is at the 6 o'clock position, pin 1 is always on the left. So going by that logic I connected leads to pins 2 and 12, and get about 2 ohms. (Just saw the updated post, and did pins 12 and 1 too, same reading)
I think the tube is good.
Now, Electronic M mentioned that the horizontal output tube could also cause HV loss, as can a bad damper tube. Before I totally lost picture, I did remove and reseat the horizontal output tube (I mistook it for the rectifier tube) and the damper tube (mistook it for a shunt regulator... yeah I know...)
Can i do a continuity test on these tubes as well?
Last edited by MRX37; 10-13-2015 at 01:37 PM.
|
10-13-2015, 01:28 PM
Threaded Mode