verticle problem

[timmy]

hey all, im working on this 48 motorola table top 7 inch , but as you can see this is a scope 7 inch crt. i went over all resistors unless i missed one but i dont think i did but these lines and rolling i cannot find whats going on here. i subbed tubes and changed resistor values around on the vert hold and vert size but no luck. if i shorten the pic top and bottom with the vert size it will become better stable but i cant widen the screen up and down because it goes crazy. any ideas where i might look as i probably missed something here. these lines may not be there and then they come right back and the longer i leave it on the worse it gets. i even tried another vert pot and vert size pot nothing changed. would something possibly in the IF section do this because upon getting it going for the first time i had nothing, no sound or picture until i rotated the pot for channel 3 and i got picture and the sound but had to rotate a different pot to get the sound good. thing here is there is an old piece of paper tape that had writen on it " if dead" so i dont know if this was an existing problem or not and then i got it with the IF problem. this is why i am wondering if an IF problem would give these lines. one other thing, does anyone here know how to read mics colors, i got a mica that has , red, green , brown , colors ?