How Many Problems Can You Spot

[vts1134]

After fixing the ion trap in my 630ts I fixed a vertical sync problem and now I am at the point you see below in the video. In the video I start by tapping the front face of the kinescope, then I tap lightly at the neck. As you can see the set does not like this one bit.
I also have a bit of a wave in the picture close to the center at the right hand side of the image.
The kinescope has been rebuilt and displays a much brighter picture than another one that I have. My other tube also has the same picture jumping when I rap on the neck of the tube, but it is no where near as dramatic as this one. The ripple at the right of the image is not present with the other kinescope.
There is a fair amount of picture smearing as well. I think this will be cleared up with an alignment. Some one please correct me if I'm wrong on that.
The picture quality just doesn't seem nearly as good as I think it should be. Maybe this will be cleared up by an alignment also.
Any one spot any other problems that I missed? If this were your set on the bench where would you go next?
http://www.youtube.com/watch?v=6GmMZkNLtS4