![]() |
|
|
Thread Tools | Display Modes |
|
#5
|
||||
|
||||
|
I do a lot of these IF can repair jobs and 22 PF for FM, 100 PF silver mica caps for AM seems to work fine on every one I did.
Pretty much every tube type radio I work on now except the older type from the 30's and 40's with the trimmer caps in the IF cans has this mica cap problem. I have some videos on my youtube channel of repairing the cans. These with the phenolic base will hold up easier than the type with the plastic base...either type I carefully hold the base in a pair of vise grips and carefully drill out the rivet holding the top on, remove the mica, trim up the clamping pieces which held the mica so they don't short, then just put the new caps under the chassis and sometimes in the larger type like this they can fit up inside the can. Some of these earlier type like on Zeniths have a nut holding the top phenolic piece on and are easier to disassemble. Sometimes I have had the wires break off from the coil but I just very carefully scraped off the enamel insulation with a file and re-attached to a piece of bare wire soldered to the terminal. Sometimes I have had to carefully superglue the coil form back on. Also watch out for sticky ferrite cores. Re-align the set with the new caps and you're off to the races again and it should hold up a lot better than the flaky mica wafers. I would do a repair job on these rather than getting a new old stock unit. I think these things end up corroding/oxidizing due to the air and the NOS unit would be subject to the same forces of deterioration. Sometimes they don't show the problem until they have been used a few minutes. I just did a job on an RCA AM/FM chassis, replaced all paper/electrolytic caps, powered it up and it worked great, after about 1/2 hour audio gets noisy and then disappears and it is the bad mica cap problem showing up. |
| Audiokarma |
|
|