Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 06-09-2012, 11:50 AM
charokeeroad's Avatar
charokeeroad charokeeroad is offline
John Q
 
Join Date: Sep 2010
Location: Southern California, IE
Posts: 644
Really slow and meticuluous work Tom but on a set like that one all the care is well deserved.

Just wondering if a bead of sliver solder in paste around the reconstructed seam on the aluminum cans would give a cleaner look to the joint and if it might be stronger as well. Of course that presupposes that aluminum can be sliver soldered. I have used silver solder in paste that comes in a syringe for easy application but I don't think I've ever tried it on aluminum. If the can isn't pure aluminum but an aloy it just might stick. Silver solder has a very low melting temperature as compared to other solders. Not sure if a good high temperature heat gun would provide enough heat to melt it but a wave of a flame from a mini torch would certainly do it. If one were to position the cut in the can where the entire joint was horizontal as opposed to vertical the chances for success would be better too I would think.

Keep up the good work.

Last edited by charokeeroad; 06-10-2012 at 07:53 AM.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:19 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.