Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 07-11-2011, 12:37 AM
reeferman's Avatar
reeferman reeferman is offline
VideoKarma Member
 
Join Date: Jun 2004
Location: St. Louis
Posts: 593
Back in the old days if the set was working we would just tap the circuit board with the butt end of a 1/4" nut driver (making sure there wasn't anything with long leads on it). Worked quite well. For items like power resistors or around items where the PCB is heat discolored at the joint just re-solder them...but...it is not uncommon to have to remove the component first to clean up the leads. Then reinstall component and solder to the board. If you apply too much heat to a dirty lead and PCB at the same time the PCB copper trace always loses. Take your time, hone your soldering skills, and have fun.
Phil

Last edited by reeferman; 07-11-2011 at 12:47 AM.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:38 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.