Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 11-14-2010, 01:20 PM
kbmuri's Avatar
kbmuri kbmuri is offline
VideoKarma Member
 
Join Date: May 2006
Location: Fort Wayne, IN
Posts: 590
Inventorying my loose round B/W tubes, it would seem that (looking from back) the convention was to position the anode at 9-o'clock, and the center pin of the 5-pin group (pin 12) at 6-o'clock. The overriding majority of my stuff is like this, and I assume it's the norm. Your tube is correct and I guess the wires won't go where I thought they should.

I have 3 tubes that do not follow the convention (with anode at 9:00, they are at 7:30, 3:00. and in one of my GE810's, at 4:30). The two tubes at 7:30 and 3:00 are rebuilds (seam on neck). So at least some of the tube rebuilders out there were not as diligent as was Scotty. No plans to remove CRT from the 4:30 tube to check, but I'll assume it's a rebuild too.

I didn't pull my pristine 810 very far away from the wall and checked behind with a flashlight (as you can tell from the post it was 2am). I must have had my left and right reversed, I checked for the wires and hole clearance, and then wrote my report. But as it turns out on closer inspection someone carved the slot larger to clear the wires, in the 6-9 quadrant, sometime in its ancient history. It looks like the tube in it is normal too.

So I retract my suggestion, lesson learned.
__________________

Do not attempt to adjust your set.
Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:13 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.