Repairing old 1951 sentinel 424

[Patnukem]

That is a nice cabinet, to bad my tv will not fit. mine is in ok shape the outside got kinda scratched getting it down to KC from Omaha.

I have gotten the new coil in as well as a ton of parts the sound is working very well and tubes are all working and checked on my Jackson tube tester. I still can not get the HV to work with the neon test, it was working fine a couple of weeks back. Could the Fried Hor. Lin. coil when it shorted kill the flyback? I think I checked the Flyback windings for shorts and all seemed ok not sure if I did this before or after the coil short i may recheck them.

Also with the new Resistors I replaced the Vertical Output Transformer is still making noise but it is a lot higher pitched then before, the windings seemed ok here as well should I wonder what one I should replace first the vert. output or the flyback? or is there something else to try? I have switched out all the tubes in the HV box with others and that did not do it. I do not think I could see the filament in the HV rect. light up but I doubt it would with no HV.

Here is a picture taken when it was working


here are some current ones of the cabinet front that was protected thanks to the doors and the chassis.