![]() |
|
#2
|
||||
|
||||
|
I've never worked on a "Prima", but your problem is definitely micro-related. It seems to be performing the POR (power-on-reset) and nothing more. Have you checked the crystal (or resonator) that feeds the clock signal to the micro? I've seen a few Sanyo and Sharp sets that had bad/dead micro clock crystals. Then again, it could be a stuck data line from the EEPROM to the micro - scope those out to see.
Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! Last edited by Findm-Keepm; 12-20-2008 at 10:50 PM. Reason: spelling... |
|
|