Westinghouse TV no picture : Strip or fix?

[JesusJones]

OK I AM thoroughly CONFUSED. LIke a monkey in space.
I was looking over the the wiring of this tv. And it isn't an exact match to the schem. OR this TV is wired up very wrong. I just don't know.


According to the schematic the damper tubes pin 5 should be hooked up to the power supply.(Point 1 for 60hz operation) Instead in the TV pin 5 is directly connected to pin 1 of the horiz output tube.

PIn 6 of the damper tube is also directly connected to the 60hz line right from the wall. It then goes (via 25 ohm sand resistor) to pins 7 and 6 of the horiz output tube.

And pin 3 of the damper goes to Lead 5 of the HV rect flyback transformer thing.(In the box) Pin 8 of the damper goes to 3cb6. And pin 7 of the damper goes right to pin 2 of the horiz output.

What confuses me here is that the horiz output should be connected to the high voltage Through a 8 k resistor then an adjustable one (Those resistors are there) But it goes from pin 5 of the damper instead of the Power supply Or 256 volt line.
And pin 5 of the damper should be hooked up to point 1 on the power supply(Which it isn't)
I AM STUMPED. STUMPED I TELL YOU

If you would like I will take detailed pictures then edit them on paint to show you what I mean. And point things out

P.S. The voltage on v15's plate should be 220v and it is much less than that. I am trying to give out as much info as I can here

P.P.S. No it is wired right I am just stupid. THe wire was hidden behind a large paer cap.The 256v goes to the 8 K resistor. Then it also goes up to the damper tube(pin 5)