![]() |
|
#28
|
|||
|
|||
|
As Steve K. said, that set you have has a power transformer - so no hot chassis. But the radio you're starting on (5 tube RCA) is most likely a "hot chassis" set. Let me guess, the five tubes are 35W4, 50C5, 12BE6, 12BA6, 12AV6? In order to save the cost of a power transformer (the single most expensive and heaviest part of a small radio), the radio and tube manufacturers came up with a set of tubes that, when strung in series, equaled roughly the power line voltage - 50+35+12+12+12=121 volts. Close enough to the power line to work well. All the tube heaters draw .15 amps, so in series the voltage drops work out. To generate the B+ the tubes need, they rectified the line voltage with the 35W4, and smoothed it with a couple of electroltyics, yielding something on the order of 150v. It works well, but it also means that the set's "ground" is essentially one side of the power line. And this was in the days before polarized plugs and grounding prongs. You have a 50-50 chance that the chassis will be connected to the "hot" line, so if you were to, say, touch the chassis while leaning on a radiator (grounded), you'd get a nasty shock.
To make matters worse, a lot of the earlier sets (espeically when they were the octal series of tubes - 50L6, 35Z5, etc) had metal screws that connected to the chassis and were exposed on the bottom. In later years, they got creative. The metal chassis was no longer "ground" but connected through a resistor and a capacitor. This works pretty good, and is safe - at least until the cap shorts. In some of the even later sets, the knobs can't even be pulled off the front - the chassis must be pulled out the back, off the knobs. This is because by making it so that the knob can't be pulled off (metal retaining clip inside), the metal shafts can't be exposed, which would potentially be line connected. They didn't care about lost knobs. Only lawsuits. Now, that doesn't mean these radios are unsafe to use, just be careful and use common sense. And once in the cabinet, the radio will be fine. But when working on it, either use an isolation transformer, or simply be careful to only touch plastic knobs when the radio is plugged in. I always put some knobs (any random junk knob will do, if you're worried about them getting damaged) on the chassis when I'm working on it, regardless of wether it's a hot chassis set or not. It makes it easier to turn the shafts when testing, and of course, on those transformerless sets, it's a safety measure. And don't be shocked (pun not intended) if you get a tingle from a transformer type TV or radio chassis. There's typically a bypass cap that's connected between the AC line and the chassis to reduce noise. These were originally regular paper type capacitors. When they're bad, they start to leak, and then you get voltage on the chassis. Another reason to replace capacitors. And you're not going to find the parts you need at Radio Shack. The electrolytics you need are 160 volt rated, and the normal caps you need are at _least_ 200 volt rated. They don't carry stuff like this anymore. You need to go to an electronics store, or order parts online. Justradios.com has a great price on a kit of 240/230 common capacitors (non-electrolytic). It's $70, but the shipping is free, and it's much cheaper in the long run over buying them one at a time. I use these caps and I'm very happy with them. If you get the little yellow ones, be sure to pick up .047's too, they're not in that kit, but you're going to need/want them for five tube sets. They carry electrolytics too. -Ian |
|
|