![]() |
|
#11
|
||||
|
||||
|
Quote:
![]() Jumpering across a defective switch may get the set working again, but it is definitely not the correct way to "repair" such a problem (or *any* television or radio problem, for that matter). In fact, the radio hadn't been repaired at all, just restored to service with a makeshift technique; the correct repair was never made. Further, with the radio constantly on even with the television off, and the main power cord still plugged in, this kind of thing could have been the heck of a fire hazard had the transformer not burned out (or the thermal fuse, if there is one, did not open) when it did--especially if, as you say, the set had remained plugged in "for many years". Seems to me the former owner was not even aware that the set was plugged in and the radio on. Makeshift repairs are meant to be temporary at best, until the proper components to repair the problem correctly can be obtained and installed. In fact, had this been a CRT HV problem or any other involving high voltages and possible shock or other hazards, such temporary repairs would be considered absolutely unacceptable. Television repair persons in the business simply do not do makeshift repairs. I seriously doubt that any TV technician jumped the switch in that set to get the radio working; rather, this sounds to me like the kind of thing a DIY type would do. (For that matter, so is replacing the original on-off switch with a toggle, as I mentioned above.) Reputable TV repair shops will not tolerate their technicians doing such haywire, slap-dash jobs as that, of course. If a real TV repair technician, who knew what he/she was doing, had been working on the radio chassis, the person would have done the job properly and replaced the switch or the entire potentiometer/switch assembly.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. |
|
|