Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #10  
Old 08-09-2018, 05:36 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,519
I then did the IF board. It was simple to remove. After a good cleaning, all the resistors were replaced with 1W. I then added solder to each ground stud to beef them up. I also checked each coil. All was good.
After the board was installed, I wrapped each wire around its stud 1 or 2 turns. Then cut off the excess wire leaving a small 3/32 end sticking out. This is to aid in removing the wire in the future. Then each one was soldered.






Last edited by Crist Rigott; 08-09-2018 at 05:48 PM.
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:32 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.