![]() |
|
|
|
#1
|
|||
|
|||
|
Disarming CRT
I know this has been covered before but with the new server I didn't get any results.
What is the safest way to kill the vacuum in a CRT. Thanks Jim |
|
#2
|
||||
|
||||
|
Use ice pick (sharp pointed inst) and pierce the soft iron bottom of the high voltage anode, safest way, worked for Philips Consumer Electronics for 12 years and this was the only approved way of airing a CRT.
|
|
#3
|
|||
|
|||
|
I normally just break of the exhaust tip with a pair of wire cutters.
|
|
#4
|
||||
|
||||
|
We didn't want any glass particles, clip the tip and glass will fly, you had better have safety glasses on when you do it. The rules for safety are why we punctured the anode, had a guy in a prototype lab who used to air tubes by kicking the neck, that is till he took a bad shot at one and sliced his leg open, after that they used to call me to the lab with my ice pick.
|
|
#5
|
||||
|
||||
|
Hammering anywhere near the CRT sounds a bit scary to me. I usually place the CRT in a cardboard box large enough to enclose everything but the very end of the CRT, and fold the box flaps around the neck. Then I snip/break the exhaust tip.
That's the way my uncle Art (Margolis) taught me.
__________________
From Captain Video, 1/4/2007 "It seems that Italian people are very prone to preserve antique stuff." |
| Audiokarma |
|
#6
|
||||
|
||||
|
Safest way
The safest way if you have not done this before is to have an experienced person do it for you.
__________________
Barrymore's Conclusion. The thing that takes up the least amount of time and causes the most amount of trouble is sex . |
![]() |
|
|