|
That's interesting that there is a -90 volt fixed bias at the grid of the horiz output tube...usually the set relies on grid leak bias only for the tube.
I would remove the tube from the socket and check the grid voltage, this will tell if there is a tube related short. 106 ohms instead of 47 is not good...I would replace the resistor feeding the grid.
Also would be good to take a scope and check for an AC signal at the grid.
If there really is only -2 volts at the 6BG6 grid this is hard on the tube, and I would check it after making repairs to the resistor circuit. I have observed lack of bias voltage destroy horizontal output tubes.
Last edited by Chad Hauris; 01-20-2007 at 07:34 PM.
|