Jordan -
It looks like excellent work so far!
I like your idea of mounting a terminal strip inside the chassis, then using it as a common for all your under-chassis caps. A neat arrangement and excellent physical mounting stability. If you recall, I chose exactly the same spot for my electrolytics, but mounted them tranversely in gobs of electrical tape, and tied all the negs together and soldered the common bunch of leads to the voltage-divider-resistor lug, using the lug as support. It's solid enough, but not great. Your solution is superior.
As far as the horizontal-drive control setting, yeah, cranking it all the way up might be a little hard on the 6BG6, but probably not catastrophically so. Turn it all the way down and you should have nothing at the plate of V20. As you turn the control up, there'll be a go/nogo point at which V20 starts conducting. Just leave it there, that should be enough to give you a bright screen. The only penalty I'm aware of for having it too high is a series of one or more "drive lines" will appear vertically on the left half of the picture, which is annoying but not dangerous, and at this point since you still have no picture, unnoticeable as well. Wouldn't hurt to turn it all the way up, just once, to see if there's any effect on the CRT screen.
It would appear from your photos that you do have a different tuner than the rest of the CX-33's on AK. At least the metal cover hints in that direction. Compare it to retrohacker's photo here:
http://audiokarma.org/forums/attachm...8&d=1146310262
and mine:
http://audiokarma.org/forums/attachm...6&d=1147575217
and notice the big brown bakelite drum turret with contact points distributed about the curcumference. I've never seen this drum turret covered by a metal plate before, either in actual TV pics or in service documents. I think if you pull the metal cover on yours, you'll see a bunch of parallel wafers instead of the brown drum. Page 7 of your Sams 112 vs. Page 10 of your Sams 160, to be more precise.
If you can hear the 15.75 Khz "singing" of the horizontal oscillator, one would think you'd have raster. At this point I might urge you to consider the 16RP4 on eBay (
http://cgi.ebay.com/ws/eBayISAPI.dll...=190073211353). They don't show up often, new. Sylvania 85's are great tubes, and given it's in the original carton, it's packed in such a way that it won't bounce around. If you insist on having it double-boxed (which he ought to do anyway), I would expect it to arrive safely. I've gotten a few that way, shipped cross-country, in good shape. Given that you've already measured yours as very weak anyway, you'll want a fresh one at some point. Might as well be now, and you can rule out (probably) the pic tube you have.
But first, do some voltage checks of pin 2 of the CRT while adjusting the brightness control. It ought to go both positive and negative, with respect to ground, depending on where the pot is set -- around -80V at minimum, down to zero and then a little positive, maybe as high as +30V. Depending on how well toleranced R43 and R2 are. If not, your brightness pot or R43 could be bad, leaving you with a black screen, despite having plenty of HV.
Since you've already had one problem with dirty tube sockets, it wouldn't hurt to rock each of the tubes in the video strip around, just in case there's a similar problem there. If you're comfortable with doing this while power is on, you ought to see some flashes or sparkles on screen when you rock the tubes, assuming the CRT isn't shot, but be very careful reaching in there to rock the tubes. Wear gloves and all that.
You're definitely on track, and you should be enjoying your vintage Capehart any time now. As long as you're having fun, go for it!
- Kirk