|
Thank You Andy, Yes, I know about that resistor/fuse, .1 ohm 1/2 watt, mounted in eyelets on the board. It's open.....
Part number fnf12nr10ku (sony 1-202-933-61) , and it is part of bdent.com's kit #4 which I ordered.
This seems to be a newer chassis, as some of the solder joints to the board that I would consider stressed by either component size, or thermal dissapation of the component have eyelets installed in them, increasing the solder contact area, as well as providing a mechanical backstop for movement on both sides of the board.
I have checked the Horizontal Output Transformer solder joints, and while (to my somewhat expert eye) they seemed good, I cleaned out the old slobber and put in some good Kester 44 60/40 . (The old crap actually outgassed as I heated it).
When I removed the Horizontal Output Transistor, I found that only the tab area of the transistor (25 - 33 % of total area) had any Thermal transfer compound on it AT ALL. Can you say "OVERHEATING" ???? I don't blame it for going belly up..........
My only hope was that that expensive dual transistor in the power supply was good, despite the readings that lead me to believe it is shorted. It would be a real kick in the shorts if the new one I ordered reads the same.
__________________

Nothing is ever completely fool proof, because fools are so ingenious.
|