View Single Post
  #12  
Old 12-26-2006, 08:21 PM
blue_lateral's Avatar
blue_lateral blue_lateral is offline
...
 
Join Date: Mar 2005
Location: Washington State
Posts: 530
Hmmmm.... Well I am not familiar with that set at all but......

I think the tuner *has* to be working, on at least one frequency. As far as I know, the UHF tuner converts down to the VHF range, effectively making the set double-conversion. In english, the signal is going through the VHF tuner on UHF, too. I think. A schematic would help.

Is the signal really weak on VHF also? Maybe the balun is blown out. It used to happen from lightning. If there are 300 ohm screw terminals on the back, like most old sets, (probably), then inside the back there will be a piece of twin lead going from the back to the tuner. The first part it goes to on the tuner is the balun. It probably has two windings. I think there would be continuity between the wires connected to the back. There would also be continuity between the two wires soldered to the tuner, if you unsoldered a lead, but no continuity between one of each. I think. If the signal strength is good, this isnt it.

Next, maybe there is an RF amp stage in the VHF tuner that is not used on UHF? Maybe a tube? Gotta look at the schematic for that.

Maybe it's time to see if there is anyone still rebuilding tuners......

John
Reply With Quote