Thread: Muntz Combo!
View Single Post
  #17  
Old 11-20-2003, 12:41 PM
Jeffhs's Avatar
Jeffhs Jeffhs is offline
<----Zenith C845
 
Join Date: Feb 2003
Location: Fairport Harbor, Ohio (near Lake Erie)
Posts: 4,035
Re: Muntz combo!

polaraman,

If by "jumbled" you mean your set's picture is slanting lines up or down the screen, I'd check the horizontal circuits (tubes first). Either the oscillator or AFC tube is bad or something is haywire in the control circuitry itself (resistors off value, etc). If the lines are slanting downward, your horizontal oscillator is running too fast; if upward, too slow. A good way to remember this is by the following: One can always run faster downhill than uphill. (I read this in an old TV repair book some years ago.) Also, the number of slanting lines on the screen will give you a rough idea of how far off frequency your horizontal oscillator is. If you have only a few lines, you are very close to 15,750, and all that's likely needed is a slight adjustment of the horizontal hold control. However, if you have more slanting lines on your screen than you can count, the oscillator is way off frequency. This can happen if someone has been fiddling with the horizontal oscillator coil slug and has screwed it too far out of the coil, or removed it from the coil altogether. Reinserting the slug in the coil and readjusting it should bring your picture back; if not, check the tube and the circuits I mentioned, in that order.

Note that if your horizontal oscillator is off frequency by any great amount, it can affect the high voltage.

Note also that if your horizontal sync is out of whack, but not enough to destroy your monochrome picture, the color will go out of sync at this time as well.

Do not operate the TV for any length of time with the horizontal oscillator or output tubes out of their sockets, or if the horizontal oscillator or output tubes are not lit or not conducting for any reason. Tube-powered transformer-operated TVs, monochrome and color, are designed so that the horizontal circuits operate on grid leak bias. The drive signal from the horizontal oscillator keeps the plate current of the output tube from going sky-high. If the drive signal is not present, there is in turn no bias on the grid of the output tube, which causes the tube to draw more plate current than it should. This will, of course, cause the circuit to overload the power supply; if the PS is not fused, this can and often does lead to eventual destruction of the low-voltage rectifier tube and/or power transformer (more likely the latter).

BTW, I like that cabinet. Very stylish. Madman Muntz must have had a good eye for cabinet styling, or else he got his cabinets from a cabinet maker who did.

Ninety-nine cents at the Goodwill for that entire set? That's a great score. Get the TV working and you'll have a set to be proud of. I like old TV sets and nice furniture myself. If my apartment weren't so small, I'd try to find a set like yours (or one of those nice big RCA three-ways as I saw a pic of on another post here). Those old 3-way sets were good (I had a great-uncle who had an RCA like that; he liked it and had it for years--in fact, when the TV eventually gave up, he just put another set in the opening left by the old chassis and made a frame around it; I had another great-uncle who did the same thing with his RCA three-way when the TV quit), but as the other poster said, they are very long and can take up an entire wall in one's living room. They are nice to have if you have the space, though.

__________________
Jeff, WB8NHV

Collecting, restoring and enjoying vintage Zenith radios since 2002

Zenith. Gone, but not forgotten.

Last edited by Jeffhs; 11-20-2003 at 01:08 PM.
Reply With Quote