|
With the correct signal at point 6, the sync seperator is ok. I thought that was what you were looking at. Now I understand. Is the hold control centered. This would indicate the oscillator is on or close to the correct frequency. Sounds like you are. I looked back at your previous thread about the size problems. Is there a setting of the lin control that produces a stable lock? I have seen the setting of the height and lin controls affect the stability of the sync. Looks like feedback for hold is off the cathode of the output tube through c507 (you did replace that one right?) the hold control and a resistor to the grid of the oscillator. Feedback from the plate of the output to the grid of the osc tube only has a few caps I would replace them regardless of how the check. I checked Sams and RCA schematics and both call for about 100volts on pin 1 of the 6ka8, so the 97v you measure should be close enough.
For servicing the chassis, I use a color test jig. I have a sylvania ck3000 test jig. They show up ocassaionally on ebay and are extremely useful by allowing you to put the chassis on the bench out of the cabinet for service. There are several manufacturers of these, they are basically a crt in a case with the appropriate loads for convergence and the deflection adaptors. Mine even has a hv meter inline so you can monitor the high voltage.
Bill R.
|