John -
Yes, I wanted to verify that the oscillator was on frequency after recapping and changing resistors in that section. Plus I wanted to make sure that the horizontal hold control hadn't been disturbed (the chassis has only been in and out about eight or ten times so far..

)
The waveform I am seeing is at the grid pin of the HO tube socket. I've checked R729 and it is within spec. I have the HO tube out for testing, but am going to put it in and see what I get at that pin as well. I also plan on measuring the screen voltage then as well - with the tube out the screen voltage is simply B+ - and a bit high at that.
I haven't looked at C448 as it is a ceramic according to the parts list, but could measure it and change it if necessary.
As far as I know, the damper isn't getting hot. I haven't looked at it closely though; I focused on the HO tube since that was the first one I saw with a glowing plate.
Will keep everyone updated....
Jim
Will remove the socket from the CRT and see what happens when I get home tonight.