View Single Post
  #19  
Old 11-13-2006, 07:12 PM
N9ZQA's Avatar
N9ZQA N9ZQA is offline
VK Member
 
Join Date: Feb 2005
Location: Joliet, Illinois
Posts: 161
John -

Yes, I wanted to verify that the oscillator was on frequency after recapping and changing resistors in that section. Plus I wanted to make sure that the horizontal hold control hadn't been disturbed (the chassis has only been in and out about eight or ten times so far.. )

The waveform I am seeing is at the grid pin of the HO tube socket. I've checked R729 and it is within spec. I have the HO tube out for testing, but am going to put it in and see what I get at that pin as well. I also plan on measuring the screen voltage then as well - with the tube out the screen voltage is simply B+ - and a bit high at that.

I haven't looked at C448 as it is a ceramic according to the parts list, but could measure it and change it if necessary.

As far as I know, the damper isn't getting hot. I haven't looked at it closely though; I focused on the HO tube since that was the first one I saw with a glowing plate.

Will keep everyone updated....

Jim

Will remove the socket from the CRT and see what happens when I get home tonight.
Reply With Quote