View Single Post
  #7  
Old 10-11-2006, 08:52 PM
ARC Tech-109
Guest
 
Posts: n/a
From experience dont leave the sets in the instant-on position as I lost the green gun on my magnavox combo. I could shoot it with my B&K and as long as the set was actually operating the tube remained good but after it went idle with the tubes warm it began to sink eventually turning into a K+G1 short that couldnt be removed. Given the availability of older triad pix tubes I would lean on keeping the heater time down to just operating only besides a set running in "standby" is going to pull around 100 watts or slightly less and at 0.08 cents per kilowatt hour it starts to add up.
Leaving the set plugged in without the instant-on feature wont hurt a thing provided the noise filter cap across the AC line is good and the incoming line itself is fused. If its not fused consider adding one just to be on the safe side.
109
Reply With Quote