|
Ok so I found the SAMS, and rigged up a power cord, so the troubleshooting will now begin. After powering it up, it was just as I had remembered. A blank white raster and no sound. Switching between tv and av input mode makes no difference and I double checked the setup switch, as was pointed out to me earlier. I've attached a couple pictures, one showing the screen, and the other showing the chassis. I'm suprised it's as clean as it is, after sitting in storage in a dusty plumbing shop for the last ten years or so. Next thing I think I'll do is feed a cable tv and composite video source to it and see how far the signal gets. I'm assuming that with just raster and no sound, I should check the IF stages and go from there. Does anyone here with experience dealing with this vintage of sets have any suggestions?
|