Ahh welp, I think I should bring this old thread back to life. After getting frustrated and nowhere with my CTC9 chassis (video amp heater still won't light up, tube is good but for the life of me I can't find the fault, but power and sound work) I decided to do some work on the chassis. My chassis is the KCS109C. I recapped the back of the chasses as well as installing new electrolyrics and 1N4007 diodes in place of those large and stinky selenium rectifiers. Without the large selenium recifiers and elecrolytics it looks kind of empty.

And you guys are right, the board is a major pain to work on, and I do mean major.

It looks like it was honestly a junk set, because almost every tube was missing from the board except the audio amp, but everything else looks intact. There seem to be radial leaded black beauties as well as paper capacitors on the PCB. Are they radial leaded black beauties? Also there are the brown and maroon colored mica capacitors, the exact same ones found in my CTC9 chassis. Also, the yoke fell apart, the glue holding the part which makes it fit snugly over the neck seperated from the coil part. That is going to be a challenge to try to fix. The tube shields on the PCB are rusted, but the PCB, wires, chassis, etc all seem to be in decent condition. I can test the chassis for power and sound out of the cabinet, but to test the picture I'll have to put it back in the cabinet. Not only that, the insulating paper that insulates the chassis from the cabinet is brittle. I'm going to try that paint Whirled One suggested. Then I'm going to try to use some sort of varnish or something on the inside to insulate the inside of the cabinet from the live chassis. I plan on using a matching transformer which does a good job in isolating the antenna connection, but I want to try to get some original parts, if I could get them from a junk set or something. If anyone has commends and suggestions, please offer.
Thanks again.
Jonathan