View Single Post
  #14  
Old 06-26-2006, 07:29 AM
Bobby Brady Bobby Brady is offline
Banned
 
Join Date: Jun 2006
Posts: 334
I guess I will stop til I get my meter working.

I had purchased NOS electrolytics that are exact replacements for the 4 cans in the set. They were "reformed" and checked by a pro. So, I thought I should have a good chance to have good voltages from them. I have been wanting to get a picture on this set for some time because I practically dream about it working like a ctc-15 in another thread owned by Charlie. He posted a photo of it working with the beautiful Endora in living color! I keep telling myself I can get this one to look like that. Just having it work as good as it does gives me a great feeling of accomplishment. Now, if only I could convince others that I am not crazy! The set is basically unwatchable so far but shows great potential.
I am waiting to get that Deoxit for the controls and swithces. The tuner works well as it is. Some other controls are dirty but seem to function. The service switch works but I have to have the kine bias to the max. I looked at the solder connections which all look good and usually I can see the cracks. Gray-scale seems to be very good. The width becomes more full after a couple minutes and the flyback stays rather cool. I reported it got hot but it seems that was only when I operated it for a short while with the hi-voltage adjustment changed so I put it where it was. I had the chassis on it's side for much testing and the main power transformer got so hot I could not hold my hand on it. I guess that's normal? I need to check the voltages at those NOS cans but it'll take me awhile to get my meter working. I am tempted to jump the caps with others to see if it puts the picture brighter, etc. I have an AC hum going constantly from bottom to top like a water wave so I think it is one or more of those new caps but I hope I find something else. There is that one on the vertical board but I suspect it is good.
I pulled the 2 6gh8's to put another two in while the set was on and when I was putting the chroma bandpass amp I had it a pin or two off and the screen lit up very bright. I also smelled a resistor burn a bit too. I hope that smell was not a coil. I am usually much more careful than that! At least I admit my mistakes! It did not seem to make a difference but I must have one or more burned parts now.
I had expected to buy those RCA parts on ebay but I missed the end time. It had the NOS horiz centering control I need. I will write the guy who got them and hopefully he will sell me it. Does anybody here have a burned out flyback that I could buy the red fiberboard with the centering contol from?
Thanks
Attached Images
File Type: jpg ctc-15 work 001.jpg (54.0 KB, 34 views)
File Type: jpg ctc-15 work 002.jpg (57.4 KB, 37 views)
File Type: jpg ctc-15 work.jpg (113.6 KB, 42 views)

Last edited by Bobby Brady; 06-26-2006 at 09:02 AM.
Reply With Quote