|
Hello! Glad you found us!
It would seem the most likely thing that could have been damaged was the wrong tube you tried. Do you know the type number? I guess you know that the '12' in that tube # refers to the filament voltage, so if you stuck a 6 volt tube in there you probably killed it. Other than that, if we knew what tube it was we could look up the specs on both tubes and compare them. I'd say chances are very good that no damage was done to the circuitry.
I had a CTC-31 that did some really goofy things thanks to solder joint problems. While troubleshooting it I subbed another video tube in there; the used replacement I tried was defective which unleashed some really bizarre intermittent behavior in the set.
Fixing those joints is not the easiest thing to do. To do it right you have to pull the chassis, a pain (but easier on this than some other models), and then you have to contend with the limited space they allowed.
I would also follow up on what nasadowsk suggested, the focus tube if it has one. It would also not surprise me if this was something like a horizontal output tube problem or some such. I am reminded of how my CTC-11 acted one day; it had been working fine and then the picture went small & fuzzy and then went away. I have a hard time now remembering just what the problem was; a bad electrolytic cap, I think. (there were a series of problems with that set)
__________________
Bryan
|