View Single Post
  #2  
Old 05-25-2006, 08:00 AM
Steve McVoy's Avatar
Steve McVoy Steve McVoy is offline
VideoKarma Member
 
Join Date: Oct 2002
Location: Columbus, Ohio
Posts: 1,619
The color adapter that Admiral planned to build had to be similar to the one CBS made:

http://www.earlytelevision.org/cbs_color_converter.html

Take a look at the schematic to see how simple it was.

The 4 pins on the connector in the Admiral receiver were for vertical sync, video, B+ and ground. The vertical sync was used to drive a phase comparator that controlled the speed of the motor that drove the wheel; the video was used because an extra pulse was transmitted in the red fields, and this pulse was extracted to lock the wheel in the proper phase (otherwise it could lock on any of three phases. The CBS converter and John Folsom's RX-41 receiver -

http://www.earlytelevision.org/field...rototypes.html

- don't have this feature, and you have to manually lock it to the proper color phase)

Our Gray Research monitor does have the feature:

http://www.earlytelevision.org/gray_monitor.html

The other change that was required in the receiver was the horizontal scan rate, which had to be 29,160 Hz, and the vertical scan rate, which had to be 144 Hz for color. The 4 pin connector on the Admiral doesn't provide a way to do this, so it is a mystery to me how this would have worked.

Admiral published a brochure showing their converter

http://www.earlytelevision.org/cbs_c...s.html#admiral

which does appear to change the scan rates, but it couldn't have used the 4 pin connector on their sets.

Last edited by Steve McVoy; 05-25-2006 at 08:16 AM.
Reply With Quote