View Single Post
  #19  
Old 04-14-2006, 11:10 PM
ozmoid's Avatar
ozmoid ozmoid is offline
Resident Frog
 
Join Date: Jul 2005
Posts: 111
Quote:
Originally Posted by dr.ido
I suppose you could always scan it frame by frame and then reassemble the frames in software. It might take a while though.

I've scanned individual frame before to make still images, but I've never actually tried to do any number of frames in order and reassemble them into a movie.

In the past I've wondered how viable it would be to somehow automate this process, but I've never actually done anything with it. If it could be done the resulting transfer would be a lot better than anything done with a projector and a camcorder.
There are two (most commonly used) basic ways to get the film image into a video/dvd/digital format:

1. Project the film a frame at a time onto a large lens (like out of an opaque projector) and capture it with your camcorder from the opposite side of the lens. Flip the image in software and encode it at the original frame rate of your projector (probably 15 fps). You CAN build a rig to do this, but you need the software skills to code some camera control software (and the hardware skills to build the interface) to capture 1 frame every (x) interval, and you need a projector with an adjustable frame rate and a low-wattage bulb to prevent burning the film. (In addition, of course, to the "rig" that aligns the projector, lens, and video camera).

2. Most pro facilities that provide a frame-for-frame transfer use a device that scans the film at high res a frame at a time, and assembles it in software at the correct frame rate. In this system, the flim is actually pressed against a CCD and each frame is captured as a still. Very expensive gear, I would not WANT to try and build it from scratch. Expect to pay a premium price for this service, but you can expect exceptional results.

Both of these methods eliminate the "flicker" that occurs when your projector and video camera frame rates don't match.
Reply With Quote