View Single Post
  #13  
Old 04-03-2006, 01:50 AM
Jeffhs's Avatar
Jeffhs Jeffhs is offline
<----Zenith C845
 
Join Date: Feb 2003
Location: Fairport Harbor, Ohio (near Lake Erie)
Posts: 4,035
Quote:
Originally Posted by jonnic
The other one is a 21" b/w console. It has similer styling to the combo. It partly works. It has sound and the tube lights but with a bunch of lines,no picture. I havnt delved into the combo much. I did discover the hv regulator tube looks bad. It is all smokey black and the center is crooked. If that tube is bad are the rest of the hv tubes usually bad too?
If your picture is just "a bunch of lines", your horizontal oscillator and/or AFC systems (and possibly another circuit I will mention shortly) are out of whack. If you adjust the horizontal hold control, can you get the picture in sync for even an instant? If not, I'd check the two tubes I mentioned; one of them may be defective. (The AFC is likely at fault if you can stop the picture, but not get it to lock in to proper sync.) If the tubes are OK, the horizontal sync itself is defective and must be repaired.

Many 1970s-vintage color TVs had high-voltage shutdown circuits that will cause the set to produce an unwatchable picture if the HV exceeds a preset limit, generally by throwing the horizontal sync so far off it cannot be restored to normal with the horizontal hold control. If changing the horizontal osc/AFC tubes will not cure the trouble (and the horizontal AFC system itself is OK), it's probably the HV shutdown circuit activating due to excessive second-anode voltage on the CRT. I would also replace that HV regulator tube if the plate cap is anything but vertical and solid.
__________________
Jeff, WB8NHV

Collecting, restoring and enjoying vintage Zenith radios since 2002

Zenith. Gone, but not forgotten.
Reply With Quote