View Single Post
  #2  
Old 03-27-2006, 09:15 PM
Chad Hauris's Avatar
Chad Hauris Chad Hauris is offline
VideoKarma Member
 
Join Date: May 2003
Location: West Texas
Posts: 2,085
Brad, it is probably a weak 12AT7 or 12DT8 tube in the FM tuner that is causing the problem. This radio has the tube filaments in a series circuit so if one actually burns out none of the tubes will light.

It is possible though for a tube to light up but for it to be worn out and have poor emission. I have seen this on several of these sets with weak FM.

Be careful as the chassis is connected right to the power line. Do not try to pull the knobs off as they have safety guards so people cannot touch the live control shafts. You will need to remove the chassis bolts, slightly pull on the knobs to loosen them, and pull the chassis away from the knobs. Make sure the chassis bolts go into the plastic insulators only and do not contact the live chassis.

Some maintenance issues for possible replacement may be the electrolytic capacitor...usually on this late model of radio the cap is still in pretty good condition but may begin to degrade, causing hum.
Also old radios with paper capacitors should have those replaced but in this Zenith they are probably ceramic and mylar and are likely OK. Another part that can degrade is the selenium rectifier but I think this set has a silicon diode.
__________________
Chad Hauris
http://www.youtube.com/user/retrochad

Last edited by Chad Hauris; 03-27-2006 at 09:24 PM.
Reply With Quote