Quote:
|
Originally Posted by jpdylon
As mentioned before, clean all the controls including chromatic and the service switch. THen replace the vert module. There was an updated version that is a direct replacment for the original, although I do not recall the number. As for shutting down, I'm not too sure where to start on that. i do remember that if the vert sweep fails, the raster will blank to prevent a burn line into the screen. This had alot of techs confused.
Don't forget to check to see if this has the terrible White four-lead cap. This was part of the HV regulation IIRC, and can destroy the CRT with excessive HV if not attended to. I'm not sure if that particular year is affected, but its always good to look. If you see a orange 4 lead cap at the bottom of the HOT heatsink or have two ceramics underneath the heatsink, you should be fine.
|
I agree. Those four-lead HV capacitors were very troublesome in sets which used them, and as you mentioned, they can cause serious damage to the CRT or possibly other parts of the set if they short or otherwise fail. My experience has been mostly with tube-type TVs. which did not use four-lead HV caps; I don't know that much about SS designs. I do know that all recent-model SS televisions are designed to blank the raster when the vertical sweep fails, and all color sets since the '60s/70s (IIRC) have HV shutdown systems that will either kill the raster or cause an unusable picture if the HV exceeds a preset limit. The HV shutdown in your set may be activating because of a problem somewhere in the HV supply, causing the shutdown you mention; I'd replace that four-lead cap on general principles. I'm sure others here with more experience on SS televisions than I can give you more ideas as to the cause of your shutdown problem; however, replacing that four-lead HV cap will be a start, even if it isn't defective. Obviously, the white four-legged caps are bad news and should be replaced anyhow.