View Single Post
  #18  
Old 03-03-2006, 10:54 PM
Adam's Avatar
Adam Adam is offline
VideoKarma Member
 
Join Date: Oct 2005
Location: Phoenix, AZ
Posts: 2,383
What I usually do with the resistors, is not to replace them all, (while they do burn out from time to time, not nearly as much as the capacitors) but if you get the schematic it will tell you what the resistance from all the pins on the tubes should be usually to ground. While, this won't always allow you to check specific resistors, it will tell you if there might be a bad one in any particular area. I usually don't go pulling any resistors in any particular area unless this is off my more than 10% or so, and I am already sure it isn't off because of a shorted capacitor or something.

But then I don't always know what I'm doing, I'm not really a TV repair man, I just like to fix TVs in my spare time. I usually try to avoid giving technical advice unless I'm absolutely sure what I'm saying, but it has been really slow here this week and I want to write something just to give people something new to look at.

Last edited by Adam; 03-04-2006 at 12:44 AM.
Reply With Quote