|
Well I think I found the issue with My NEC monitor, I found a 2 X 2 board on the back of the tube yoke area with five 1 turn pots. Adjustments don't do much, but if I push on one of the pots, convergence is perfect. I'm betting its a cracked solder joint...
Unfortunatly there are 6 wraped and soldered wires that make it imposible to lean up and resolder. The wires go into the tube yoke area. I'll see about desoldering them tomorrow.
Anything I shold be discharging in the area before going in? I know there has to be some HV in there some where waiting to bite...
__________________
- Outlaw
Main: 9090DB, Snell Type EIII's, Marantz 6100, TEAC PD-D2500
LR: Motorola tubes, EL84 outputs, , Dual 1019 TT, Sony CDP-CE105, Wharfedale Sapphire SP-89's and a 15" GV center in an infinite baffle
Home Office: Sansui 6060, Sony CDP-C305, Original Advents
|