View Single Post
  #6  
Old 08-18-2005, 09:38 AM
veg-o-matic's Avatar
veg-o-matic veg-o-matic is offline
Huh?
 
Join Date: May 2003
Location: Baltimore
Posts: 454
Did some work last night.

Checked continuity on all the new tube socket pins. Found a couple that were dodgy and fixed 'em.

Oddly, the trace that I fixed with the copper tape had good continuity. Chad, I took your advice and ran a wire from two components across the bad section anyway. Sort of like wearing a belt with suspenders

The chassis is still out of the set, as I ran out of time and want to double-check things before I go shoving it back in again.

There's another thread about an HV anode connecter in one of the forums that's making me think. Last time I put the chassis back in and snapped the HV connector back in the little hole on the tube, I noticed that the fit wasn't real tight. There was some lateral play and--I think but am not totally sure--a little up and down play as well. Should the little springy thing fit in the hole really tight?

Thanks for all the help, guys! With any luck, I'll be watching the set soon!
__________________
Reply With Quote