I have an RCA color set, 19", bought new in 1999, that shows very good pictures on cable in my area. Haven't had to readjust the color controls in months, even when watching DVDs or VHS. I am over 30 miles from Cleveland (45 miles from the stations' transmitters, which are located in a southwestern suburb of the city), and get fair to poor reception with an antenna; the only way I can get decent reception here is on cable (Comcast digital).
I have no idea what the color quality of Cleveland's first commercial UHF station, WUAB on channel 43 (then independent, now NE Ohio's UPN affiliate) was (the same for WVIZ, Cleveland's PBS channel 25, which signed on in 1965), as I didn't have color TV when the station first went on the air in 1968. This station now has the most powerful transmitter (five million watts ERP) of all TV stations in NE Ohio, surpassing even that of CBS channel 19 (3.7 megawatts, IIRC). The CBS affiliation was switched from channel 8 to 19 some years ago; now, folks west of Cleveland have trouble seeing it without cable. I think 43 should have taken the CBS affiliation when it had the chance to do so, as it had already installed its fabulous 5-megawatt ERP transmitter shortly before the network switch was announced; 43 would have then had the opportunity to service the entire NE Ohio area with a CBS signal everyone could receive equally well, whether on an antenna or cable (the network offered it to them, but for some reason they passed on it, leaving 19 to pick it up

). But I digress.
Color quality and reception problems are a thing of the past with today's solid-state TVs and cable systems, at least in the larger cities. Some smaller cable systems in small towns have problems keeping color balance even between stations (the problems with videotape lip-sync and other problems, which may include color balance, at some smaller stations notwithstanding, like CBS channel 16 in Salisbury, Maryland, that Bryan mentioned in one of his posts). The auto-color balance systems in today's TVs are set up, supposedly, to eliminate or at least minimize color variations between channels; some of them, such as RCA's system (now called Advanced Colorview in the newest sets, but I always considered the system in my set as an updated ColorTrak even though it might not actually bear any resemblance at all to the original ColorTrak system), do a decent job of it, but the simpler systems used in other makes may be little more than warmed-over versions of the preset color controls switched in by a push switch on the front of the set (as were common in late-'60s-'80s Magnavox, RCA, etc. sets; Zenith chose not to use any such preset system in its early sets [though my 1995 SMS1917SG 19" Zenith does in fact have a picture-preference switch which enables either preset or custom color adjustments, selectable through an onscreen menu], which may well be one reason why pre-GS Zeniths always have such great pictures). For these, the only solution when the color goes out of whack is to readjust the tint control. In fact, I wouldn't even bother with that preset button, as it simply switches in controls which were set at the factory, not on a broadcast signal, but using a color bar pattern from a generator. In older sets and today's receivers as well, the quality of the picture on your screen is no better than that of the signal the TV set receives at the antenna terminal, no matter how much or how little automatic processing the signal encounters on its way through the set to the CRT.