Thread: ghosts
View Single Post
  #6  
Old 05-05-2005, 08:47 PM
wa2ise's Avatar
wa2ise wa2ise is offline
VideoKarma Member
 
Join Date: Dec 2002
Location: USA
Posts: 3,147
Smile

Quote:
Originally Posted by shrinkboy

more suggestions? i and i tinkin' i don't wanna kill 1/2 a day waiting for the cable guy
Take a close look at every cable and connection. The cables behind the cable jacks mounted to the walls as well. Wall jacks are usually just female-female barrels mounted in a plastic faceplate. What often happens is the outer shield pulls away from the body of the F connector. You can usually push the F connector into the cable a little. The connector body has a tapered part that is to slip under the cable braid shield and outer insulation jacket. And a crimp ring that should be squashed down to force contact between the connector and shield braid. A pair of slip joint pliars will serve reasonably well to squish that crimp ring more to reestablish contact. Also check the connections at all splitters and at the grounding thingie where the cable company feed enters the house. Be sure the ground connection stays good; it protects you and your TVs if a power wire should fall and touch the cable system. This is probably what the cable guy would do. A small crescent wrench may come in handy to loosen or tighten the connectors. Use only moderate force, not all your might, on the wrench.
Reply With Quote