View Single Post
  #7  
Old 11-06-2026, 10:08 AM
TinCanAlley's Avatar
TinCanAlley TinCanAlley is offline
VideoKarma Member
 
Join Date: Sep 2008
Location: So Cal, CA
Posts: 1,026
Quote:
Originally Posted by Username1 View Post
.

I think you should check all the components on the convergence board first, be sure
all the caps & Resistors are in spec. Then set all the controls to mid point since
you have such a far out of wack blue.... Then follow the procedures you
posted above, the order is correct and should work out fine It's just
the way I use to do it.... And just for observation comment,
overall it looks good, very good except for the blue.
Don't rule out loosening the 3 magnets and turning
them a little if you can't get it. Remember it
looked almost prefect from the factory, no
reason you can't get it there again.



.
What 3 magnets are you referring to? I know only of the static convergence magnets.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL

Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Reply With Quote