View Single Post
  #4  
Old 11-04-2026, 12:18 AM
Deathspiral Deathspiral is offline
VideoKarma Member
 
Join Date: Jun 2026
Posts: 2
I know this is an old thread but i had the exact same issue when i pressed the factory reset command on the remote in the service menu. I was going to ask you if you figured out the problem because im worried that my EEPROM got corrupted.

HV come on; then shuts off immediately with a 1 blink error code pointing to B+ on the deflection board, AC is coming into the D board, getting about 118v before it hits the bridge rectifier. HOT isn't reading shorted solder has been reflowed on the stress points.

Last edited by Deathspiral; 11-04-2026 at 12:24 AM.
Reply With Quote