|
.
I think you should check all the components on the convergence board first, be sure
all the caps & Resistors are in spec. Then set all the controls to mid point since
you have such a far out of wack blue.... Then follow the procedures you
posted above, the order is correct and should work out fine It's just
the way I use to do it.... And just for observation comment,
overall it looks good, very good except for the blue.
Don't rule out loosening the 3 magnets and turning
them a little if you can't get it. Remember it
looked almost prefect from the factory, no
reason you can't get it there again.
.
__________________
Yes you can call me "Squirrel boy"
|