Quote:
Originally Posted by ostlar
I see there are components referenced to ground on pin 3 in the schematic of the replacement, like a diode and a capacitor, could be one of those shorting out.
|
Anything is possible. I'd probably do a check on the surrounding components to make sure the short condition you were noticing before removing the flyback is gone. If it's not, then you could end up ruining the new flyback. The bad flyback could have also taken some components with it, maybe altered the values of some resistors or something
Quote:
|
I have ordered a new flyback, so we'll see if it is resurrected once it arrived.
|
If it was me, I'd remove the "working" flyback from the working set and measure it against the replacement flyback in order to get a baseline before doing the swap.
I know it's a pain to remove a flyback, but I personally think it's worth it to get more information.